C Series Piston and Connecting Rod Assembly Section 1 - Cylinder Block - Group 01 Page 1-127 Install Piston Protrusion for Emission-Controlled Engines mm in Engines built after 1/1/1994 0.584 MIN 0.023 0.635 MAX 0.025 Install the bearing shells into both the connecting rod and the connecting rod cap. Make sure the tang on the bearing shell is in the slot of the connecting rod cap and connecting rod. NOTE: If used connecting rod bearing shells are to be installed, each bearing shell must be installed in its original location. CAUTION Do not lubricate the back of the connecting rod bearing. Prevent dirt from mixing with the lubricant.
Dirty lubricant will accelerate connecting rod bearing wear. Lubricate the connecting rod bearings with a thin film of clean engine oil. Install the piston rings. Refer to Procedure 001-047 in Section 1. Lubricate the rings and piston skirts with clean engine oil. Make sure the piston ring end gaps are positioned 120 degrees apart.