Cummins — 3666003

Piston and Connecting Rod Assembly C Series Page 1-128 Section 1 - Cylinder Block - Group 01 If using a strap-type ring compressor, make sure the inside end of the strap does not hook on a ring gap and break the ring. CAUTION Compress the rings. Lubricate the cylinder bore with clean engine oil. Position the connecting rod journal for the piston to be installed to Bottom Dead Center. Take care not to damage the cylinder wall when inserting the connecting rod. NOTE: The word FRONT stamped on the piston crown will be toward the front of the block. The piston bowl will then be on the fuel pump side of the engine.