Piston and Connecting Rod Assembly C Series Page 1-130 Section 1 - Cylinder Block - Group 01 NOTE: Do not measure the clearance between the rod cap and crankshaft. Measure the side clearance between the connecting rod and crankshaft. Side Clearance Limits mm in 0.10 MIN 0.004 0.33 MAX 0.013 NOTE: The crankshaft must rotate freely. Check for freedom of rotation as the connecting rod caps are installed. If the crankshaft does not rotate freely, check the installation of the connecting rod bearings and the bearing size. NOTE: If the connecting rod is not properly oriented (tang opposite the camshaft), it will contact the camshaft and lock the engine.
Finishing Steps This component or assembly weighs greater than 23 kg [50 lb]. To prevent serious personal injury, be sure to have assistance or use appropriate lifting equipment to lift this component or assembly. WARNING Install the cylinder head. Refer to Procedure 002-004 in Section 2. Install the lubricating oil pan. Refer to Procedure 007-025 in Section 7. Fill the engine with coolant. Refer to Procedure 008-018 in Section 8. Fill the engine with clean lubricating oil. Refer to Procedure 007-037 in Section 7. Operate the engine and check for leaks.