Crankshaft Wear Sleeve, Rear C Series Page 1-132 Section 1 - Cylinder Block - Group 01 Drill the dataplate, taking care not to destroy any data printed on the dataplate. Drive the rivets in until they contact the dataplate. Crankshaft Wear Sleeve, Rear (001-067) Preparatory Steps CAUTION Use extreme care when releasing the oil pan gasket from the rear cover to prevent damage to the gasket. If the gasket is damaged, the oil pan must be removed and the gasket replaced. Disconnect the driven equipment. Refer to the OEM instructions. Remove the flywheel. Refer to Procedure 016-005 (Flywheel) in Section 16. Remove the flywheel housing. Refer to Procedure 016-006 (Flywheel Housing) in Section 16.
Loosen the lubricating oil pan mounting capscrews four revolutions. Insert a feeler gauge or shim stock between the rear cover and the oil pan gasket. Move the feeler gauge or the shim stock back and forth to release the gasket from the rear cover. Remove the capscrews from the rear cover, and remove the cover from the crankshaft flange. Remove the seal from the rear cover.