Cummins — 3666003

C Series Crankshaft Wear Sleeve, Rear Section 1 - Cylinder Block - Group 01 Page 1-133 Remove Do not nick or gouge the crankshaft with the chisel. If the crankshaft is damaged, it must be replaced. CAUTION If the crankshaft presently has a wear sleeve, it must be removed before installing a new one. Use a dull chisel that is only as wide as the wear sleeve. Make one or two soft blows with a hammer to make chisel marks across the wear sleeve. This will expand the wear sleeve, allowing the sleeve to be removed. Clean and Inspect for Reuse Clean the gasket surface of the cylinder block and rear cover. Use a crocus cloth to remove any rust or other deposits from the crankshaft flange.

Use a clean cloth to clean the crankshaft flange. Inspect the crankshaft flange for dirt or nicks. Inspect the rear cover for cracks or other damage.