Cummins — 3666003

Crankshaft Wear Sleeve, Rear C Series Page 1-134 Section 1 - Cylinder Block - Group 01 Install Do not use any kind of lubricant to install the seal. The oil seal must be installed with the lip of the oil seal and the crankshaft clean and dry to secure proper oil sealing. The combination crankshaft oil seal (A) wear sleeve (B) replacement kit for service usage is installed on the crankshaft as an assembly. The crankshaft rear oil seal must not be removed from the crankshaft rear seal wear sleeve. Install the rear cover and gasket. Install the rear cover capscrews. Do not tighten. If the oil pan is installed, loosen the oil pan capscrews to allow clearance for rear cover and gasket clearance.

The seal installation is being used to align the rear cover properly. Do not push or force the cover in any direction to prevent irregular seal lip position after seal installation. The oil seal for a wet flywheel housing requires soap on the outside of the seal case. Nothing is required on the outside of the seal case for dry housings.