Cummins — 3666003

C Series Crankshaft Wear Sleeve, Rear Section 1 - Cylinder Block - Group 01 Page 1-135 Use a crankshaft rear seal/wear sleeve installation tool, Part Number 3824078, to install the oil seal/wear sleeve assembly. Install two (2) threaded studs into the crankshaft capscrew holes. Apply a small amount of clean engine oil to the crankshaft, threaded studs, and inside of the crankshaft rear seal/wear sleeve installation tool. Position the chamfered end of the wear sleeve (A) onto the end of the crankshaft (B). Position the counterbore end of the installation tool (C) over threaded studs and align with wear sleeve, perpendicular to the end of the crankshaft.

Install the washers (D) and nuts (E) onto the threaded studs. Alternately tighten the nuts until the installation tool contacts the end of the crankshaft. Do not exceed 1/2 revolution of each nut to prevent wear sleeve binding and irregular stretch. Torque Value: 20 N•m [ 180 in-lb ] Remove the installation tool and threaded studs.