Cummins — 3666003

Crankshaft Wear Sleeve, Rear C Series Page 1-136 Section 1 - Cylinder Block - Group 01 Align the rear cover even with both sides of the oil pan rail on the cylinder block. The chart below shows the proper torque value when using either a 9.8 or a 10.9 grade bolt. The grade is embossed on the top of each bolt. Apply Dri Lock to both part numbers below during installation. Dri Lock 205 is recommended. Use Dri Lock 204 or 211, when 205 is not available. Tighten the rear cover capscrews. Trim the gaskets even with the oil pan mounting surface. Make sure the gasket trim does not enter the engine.

Fill the joint between the lubricating oil pan rail and the rear cover with Three-Bond RTV sealant, Part Number 3823494. Install the four rear oil pan mounting capscrews to the pan. The lubricating oil pan capscrews must be tightened within 5 minutes after applying the sealant. Torque Value: 24 N•m [ 212 in-lb ] Finishing Steps WARNING This component or assembly weighs greater than 23 kg [50 lb]. To prevent serious personal injury, be sure to have assistance or use appropriate lifting equipment to lift this component or assembly. Install the flywheel housing. Refer to Procedure 016-006 (Flywheel Housing) in Section 16. Install the flywheel.

Refer to Procedure 016-005 (Flywheel) in Section 16. Connect the driven equipment. Refer to the OEM instructions. Operate the engine until the coolant temperature reaches 82°C [180°F]. Check for leaks and proper operation. Rear Seal Carrier Bolt Number Bolt Size Bolt Class Torque Dri- Lock 3913638 M-6 9.8 10 N•m [ in-lb] No 3991306 M-6 10.9 13 N•m [ in-lb] Yes