C Series Cylinder Head Section 2 - Cylinder Head - Group 02 Page 2-3 Cylinder Head (002-004) Preparatory Steps Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. WARNING WARNING Coolant is toxic. Keep away from children and pets. If not reused, dispose of in accordance with local environmental regulations. Disconnect the batteries. Refer to the original equipment manufacturer (OEM) service manual. Drain the coolant. Refer to Procedure 008-018 in Section 8.
Remove all of the coolant and heater hoses. Refer to the OEM service manual. Remove the turbocharger. Refer to Procedure 010-033 in Section 10. Remove the exhaust manifold. Refer to Procedure 011-007 in Section 11. Remove the injector supply lines. Refer to Procedure 006-051 in Section 6. Remove the injectors. Refer to Procedure 006-026 in Section 6. Remove the rocker lever cover. Refer to Procedure 003-011 in Section 3. Remove the rocker lever assemblies. Refer to Procedure 003-008 in Section 3. Remove the push rods. Refer to Procedure 004-014 in Section 4. Remove the drive belt. Refer to Procedure 008-002 in Section 8. Remove the fan pulley and fan hub.
Refer to Procedure 008-036 in Section 8. NOTE: In some applications, it can be easier to remove the thermostat housing to gain access to the exhaust manifold capscrews on cylinder number 1. Remove the thermostat housing. Refer to Procedure 008-014 in Section 8. Disconnect the coolant vent lines. Refer to Procedure 008-017 in Section 8. Remove the intake manifold cover and intake heater, if equipped. Refer to Procedure 010-023 in Section 10.