Cylinder Head C Series Page 2-4 Section 2 - Cylinder Head - Group 02 Remove Remove the cylinder head capscrews in the sequence shown. WARNING The component weighs 23 kg [50 lb] or more. To reduce the possibility of personal injury, use a hoist or get assistance to lift the component. Do not lay the cylinder head on the combustion deck. This can damage the combustion deck. CAUTION Use a hoist or hydraulic arm to remove the cylinder head. Make sure the head is removed in a direct upward motion. Remove the cylinder head gasket from the cylinder block. Clean and Inspect for Reuse When using a steam cleaner, wear safety glasses or a face shield, as well as protective clothing.
Hot steam can cause serious personal injury. WARNING WARNING Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. Steam-clean the cylinder head. NOTE: Make sure to blow out all the capscrew holes. Dry the cylinder head with compressed air. WARNING When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer's recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury. Clean the injector bores with an Cummins® injector bore brush, Part Number 3822510, and solvent.