C Series Cylinder Head Section 2 - Cylinder Head - Group 02 Page 2-5 Remove the valves from the cylinder head. Refer to Procedure 002-020. Scrape the gasket material from all gasket surfaces on the block and head. Clean the buildup of deposits from the coolant passages. Inspect the area within 1/8-inch of the combustion seal ring diameter. Any wear that can be felt with a fingernail within the 1/8-inch area is unacceptable, making the cylinder head not reusable.Wear beyond this 1/8-inch area will have no effect on future combustion sealing and the usability of the cylinder head.
Clean carbon deposits from the valve pockets with a high quality steel wire wheel installed in a drill or a die grinder. NOTE: An inferior quality wire wheel will lose steel bristles during operation, causing additional contamination. NOTE: Excessive deposits can be cleaned in an acid tank. The expansion plugs must be removed before putting the cylinder head into an acid tank. WARNING When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer's recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury.
Clean the cylinder head combustion deck, exhaust manifold gasket surface, and valve cover gasket surface with Scotch-Brite™ 7448, Part Number 3823258, and diesel fuel or solvent.