Cylinder Head C Series Page 2-6 Section 2 - Cylinder Head - Group 02 Clean the cylinder block head deck surface. Refer to Procedure 001-026 in Section 1. WARNING When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer's recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury. Cylinder Head Capscrews CAUTION Do not use caustic or acid solutions to clean the cylinder head capscrews. Use of these solutions can cause corrosion and damage to the cylinder head capscrews. Use a petroleum-based solvent to clean the cylinder head capscrews.
Clean the capscrews thoroughly with a wire brush, a soft wire wheel, or use a non-abrasive bead blast to remove deposits from the shank and threads of the cylinder head capscrews. Inspect the cylinder head and valve seats for obvious damage that would prohibit reuse. Cylinder Head Inspect for cracks and damage to the deck surface that would result in loss of sealing. NOTE: If a crack in the cylinder head is suspected, pressure-test the cylinder head.