Cummins — 3666003

C Series Cylinder Head Section 2 - Cylinder Head - Group 02 Page 2-11 Lubricate the threads and under the heads of the remaining cylinder head capscrews with engine oil. Install the capscrews hand-tight. CAUTION Do not use pre-1991 certification capscrews in a 1991 or later certification level engine because of differences in capscrew length and thread engagement. Damage to the engine will result if the wrong capscrews are used. Post 1991 - New Cylinder Block or New Capscrews Always use the following procedure when you are using new capscrews or a new cylinder block. NOTE: Each 1991 and later certification capscrew has been marked with symbols and an angle specification.

The capscrew part numbers can be identified by inspecting the marks on the capscrew head. CAUTION This procedure is to be used only with the use of a new cylinder block or new cylinder head capscrews. 1 Apply a thin film of clean engine lubricating oil to the capscrew threads and underside of the capscrew head flange. Cylinder Head Capscrew Part Numbers Pre-91 Capscrew Part Number Length 1991 Capscrew Part Number Length 3907234 Short 3917729 Short 3907233 Long 3917728 Long