Cummins — 3666003

Cylinder Head C Series Page 2-10 Section 2 - Cylinder Head - Group 02 Place the flange of the capscrew against the base of the slot on the capscrew length gauge. If the end of the capscrew touches the foot of the gauge, it is too long and the capscrew must be discarded. Immediately after cleaning and inspecting the capscrews, apply a light film of clean engine oil to all of the capscrews that are to be reused. Install Make sure the cylinder head gasket is correctly aligned with holes in the cylinder block. If not aligned properly, it can cause engine damage. CAUTION Position the new cylinder head gasket over the dowels. This component weighs 23 kg [50 lb] or more.

To reduce the possibility of personal injury, use a hoist or get assistance to lift this component. WARNING Carefully put the cylinder head straight down onto the cylinder block, and seat it onto the dowels.