C Series Cylinder Head Section 2 - Cylinder Head - Group 02 Page 2-9 Cylinder Head Capscrews Inspect the cylinder head capscrews for damaged threads, corroded surfaces, or a reduced diameter. NOTE: A reduced diameter is caused by capscrew stretching. Do not reuse cylinder head capscrews under the following conditions: Visible corrosion or pitting exceeds 1 cm 2 [0.155 in 2 ] in area. Example: Acceptable - 9.53 mm [3/8 in] x 9.53 mm [3/8 in] Unacceptable - 12.7 mm [Ѕ in] x 12.7 mm [Ѕ in] Visible corrosion or pitting exceeds 0.12 mm [0.005 in] in depth. NOTE: Do not reuse a capscrew that has damaged threads or a reduced diameter.
Visible corrosion or pitting that is located within 3.2 mm [0.126 in] of the fillet. Visible corrosion or pitting that is located within 3.2 mm [0.126 in] of the threads. Stretched beyond the “free-length” specifications. NOTE: If the capscrews are not damaged, they can be reused throughout the life of the engine, unless the capscrew stretches beyond the “free-length” specification. Use capscrew length gauge, Part Number 3823921, to measure the cylinder head capscrew. Cylinder Head Capscrew Free Length mm in Short Capscrews 81.5 MAX 3.2 Long Capscrews 162.6 MAX 6.4