Cummins — 3666003

Cylinder Head C Series Page 2-8 Section 2 - Cylinder Head - Group 02 NOTE: A maximum of 1 mm [0.040 in] can be machined from the combustion surface of the cylinder head. If the cylinder head is machined, place the valve in the respective bore and check the valve depth dimension. If the depth is less than the minimum specification, the valve seat will require machining. Refer to the Shop Manual, C Series Engines, Bulletin 3666008. Valve Recess in Cylinder Head mm in Exhaust 1.09 MIN 0.0430 1.62 MAX 0.064 Intake 0.59 MIN 0.023 1.12 MAX 0.044 Valve and Seat Leakage Test Inspect the valves for indications of leakage or burning. NOTE:

If a leaking valve is suspected, vacuum test the valves and valve seats. The vacuum must not drop more than 25.4 mm Hg [1.0 in Hg] in 5 seconds. Valve to Valve Seat Vacuum mm Hg in Hg Used 457 MIN 18 New 635 MIN 25 NOTE: If vacuum does not meet the specifications, the face of the valves and the valve seat inserts must be resurfaced. Refer to the Shop Manual, C Series Engines - Applicable to Engines Built in 1991 and After, Bulletin 3666008.