Valve Seat Insert, Cylinder Head C Series Page 2-18 Section 2 - Cylinder Head - Group 02 Grind Use valve seat grinding machine, Part No. ST-685, and valve guide arbor set, Part No. 3375946, to grind the valve seat inserts. Grind the valve seats at a 30-degree angle. Measure the valve seat width. Valve Seat Width mm in Intake 3.05 MIN 0.120 3.55 MAX 0.140 Exhaust 1.52 MIN 0.060 2.54 MAX 0.100 If the width of the valve seat is not within specifications, remove surface material on the inner diameter and the outer diameter to decrease the width of the seat. NOTE: If the valve seat specifications are not obtained by grinding the valve seat, the insert must be replaced.
Measure the valve-seat-to-valve-guide concentricity. Valve-Seat-to-Valve-Guide Concentricity mm in 0.05 MAX 0.002