Cummins — 3666003

C Series Valve Seat Insert, Cylinder Head Section 2 - Cylinder Head - Group 02 Page 2-17 Hardening of the material and wear or damage to the sealing surfaces will cause the valve seals to leak. Valve Guide, Cylinder Head (002-017) Inspect for Reuse Measure the inside diameter of the valve guide bore in the cylinder head. Valve Guide Bore without Pin, Inside Diameter mm in 15.931 MIN 0.6272 15.971 MAX 0.6288 If the valve guide bore is worn larger than the maximum specified, the cylinder head must be replaced. Inspect the valve guides for scuffing, scoring, chips, or cracks. Measure the valve guide inside diameter.

Valve Guide Bore with Pin, Inside Diameter mm in 9.539 MIN 0.3755 9.559 MAX 0.3763 Valve Seat Insert, Cylinder Head (002-019) Inspect for Reuse Inspect the valve seats for cracks and burn spots. NOTE: Service valve seats are available for valve seats that can not be ground within specification. NOTE: If a valve seat can not be cleaned up by grinding it, the valve seat must be replaced; refer to the Shop Manual, C Series Engines, Bulletin 3666008.