Valve Guide Seal, Cylinder Head C Series Page 2-16 Section 2 - Cylinder Head - Group 02 Finishing Steps Batteries can emit explosive gases. To reduce the possibility of personal injury, always ventilate the compartment before servicing the batteries. To reduce the possibility of arcing, remove the negative (-) battery cable first and attach the negative (-) battery cable last. WARNING Install the thermostat housing. Refer to Procedure 008-014 in Section 8. Install the drive belt. Refer to Procedure 008-002 in Section 8. Install the exhaust manifold. Refer to Procedure 011-007 in Section 11. Install the rocker lever assemblies. Refer to Procedure 003-008 in Section 3. Install the push rods.
Refer to Procedure 004-014 in Section 4. Adjust the valve lash. Refer to Procedure 003-004 in Section 3. Install the rocker lever cover. Refer to Procedure 003-011 in Section 3. Install the turbocharger. Refer to Procedure 010-033 in Section 10. Install the injectors. Refer to Procedure 006-026 in Section 6. Install the injector supply lines. Refer to Procedure 006-051 in Section 6. Connect the coolant vent lines. Refer to Procedure 008-017 in Section 8. Install the fan pulley and fan hub. Refer to Procedure 008-036 in Section 8. Fill the engine with coolant. Refer to Procedure 008-018 in Section 8. Connect the batteries. Refer to the OEM service manual.
Operate the engine at idle 5 to 10 minutes to check for leaks and proper operation. Valve Guide Seal, Cylinder Head (002-016) Initial Check Worn valve stem seals are typically detected by excessive smoke at idle, or when the engine is unloaded and the vehicle is going downhill.