Cummins — 3666003

Overhead Set C Series Page 3-2 Section 3 - Rocker Levers - Group 03 Overhead Set (003-004) Adjust Remove the air crossover tube from the engine if equipped. Disconnect the support clamps, hose clamp, and wastegate sensing line. Remove the crankcase vent tube and any other parts that would prevent removal of the valve cover. Remove valve cover. Locate top dead center for cylinder Number 1 by rotating the crankshaft slowly while pressing on the engine timing pin. The barring gear inserts into the flywheel housing and engages the flywheel ring gear. The engine can then be rotated by hand using a 127-cm [1/2-in] ratchet or breaker bar.