Cummins — 3666003

C Series Overhead Set Section 3 - Rocker Levers - Group 03 Page 3-3 When the engine timing pin engages the hole in the camshaft gear, cylinder Number 1 is at top dead center on the compression stroke. CAUTION Be sure to disengage the engine timing pin after locating top dead center to prevent damage to the engine timing pin. Intake clearance: 0.30 mm [0.012 in]. Exhaust clearance: 0.61 mm [0.024 in]. Check/set valves with engine cold - below 60°C [140°F]. NOTE: The clearance is correct when some resistance is “felt” when the feeler gauge is slipped between the valve stem and the rocker lever. Locate top dead center for cylinder Number 1.

Check/adjust the valves indicated for STEP A (I = intake; E = exhaust). After tightening the rocker lever locknut, check the valve clearance to make sure the valve clearance has not changed. Torque Value: 24 N•m [ 212 in-lb ]