Cummins — 3666003

Overhead Set C Series Page 3-4 Section 3 - Rocker Levers - Group 03 Be sure the engine timing pin is disengaged to prevent damage to the engine timing pin. CAUTION Mark vibration damper and rotate the crankshaft 360 degrees. Set the valves indicated for STEP B. After tightening the rocker lever locknut, check the valve clearance to make sure the valve clearance has not changed. Torque Value: 24 N•m [ 212 in-lb ] NOTE: If the seal is not damaged, it can be used again. If the seal is damaged, install a new seal. Install the rubber seal into the groove in the valve cover. Start the installation at the overlap area shown in the illustration. Do not stretch the rubber seal.

If the seal has more overlap than shown in the illustration, trim the length to provide the correct overlap. Install new sealing o-rings on the capscrews. Install the valve cover and wastegate sensing tube. Torque Value: 24 N•m [ 212 in-lb ]