Rocker Lever Cover C Series Page 3-12 Section 3 - Rocker Levers - Group 03 Rocker Lever Cover and Crankcase Breather Assembly 1. Breather 2. Rocker Lever Cover. NOTE: If the rocker lever gasket is not damaged, it can be reused. If the rocker lever gasket is damaged, install a new gasket. Install the rocker lever gasket into the groove in the rocker lever cover. Start the installation at the overlap area shown in the illustration. Do not stretch the rubber rocker lever gasket. If the rocker lever gasket has more overlap than shown in the illustration, trim the length to provide the correct overlap. Install new sealing o-rings on the capscrews. Install the six capscrews into the cover.
Tighten the capscrews in the sequence shown. Torque Value: 24 N•m [ 18 ft-lb ]