C Series Crankcase Breather Tube Section 3 - Rocker Levers - Group 03 Page 3-13 Finishing Steps Install the capscrew into the support bracket for the turbocharger wastegate actuator hose (on-highway vehicles). Temporarily install the crankcase breather tube and hose. Refer to Procedure 003-018. Install the air crossover tube (off-highway vehicles). Crankcase Breather Tube (003-018) Remove Remove the two hose clamps from the crankcase breather. Remove the two breather tube support bracket capscrews (A and B). Inspect for Reuse Inspect the hose and tube for restrictions, cracks, or other damage. Replace the hose and tube if damaged.
Install Install the breather tube and hose clamps with the outlet oriented to allow the best routing of a 2.54 cm [1 in] diameter breather hose to the oil pan flange. Tighten the capscrews for the breather tube support brackets. Torque Value: Step1 24 N•m [ 18 ft-lb ] Step2 43 N•m [ 32 ft-lb ]