Tappet C Series Page 4-4 Section 4 - Cam Followers/Tappets - Group 04 Finishing Steps Install the rocker lever cover and gasket. Refer to Procedure 003-011. Install the crankcase breather tube. Refer to Procedure 003-018. Tappet (004-015) General Information The valve tappets are mushroom shaped. The offset position of the tappet against the camshaft lobe causes the tappet to rotate as it lifts the push rod. The ball end of the push rod fits into the ball socket in the tappet. The other end of the push rod has a ball socket in which the ball end of the rocker lever adjusting screw operates.
Loose rocker levers and the need to reset the valve clearance frequently can indicate camshaft lobe or tappet wear. If an inspection of the levers, valve stems and push rods does not show wear, then tappet or camshaft lobe wear can be suspected.