C Series Tappet Section 4 - Cam Followers/Tappets - Group 04 Page 4-5 Preparatory Steps Remove the crankcase breather. Refer to Procedure 003-018. Remove the rocker lever cover. Refer to Procedure 003-011. Remove the rocker levers. Refer to Procedure 003-008. Remove the push rods. Refer to Procedure 004-014. Remove the crankshaft pulley/vibration damper. Refer to Procedure 001-052. Remove the front gear cover. Refer to Procedure 001-031. Remove Oil Pan Installed The valve tappets can be removed with the oil pan installed by using tappet removal tool kit, Part Number 3822513. The kit consists of: 1. Valve Tappet Tray - Quantity 1 2. Dowel Rods - Quantity 12 3. Rubber Bands - Quantity 12 4.
Nylon String - Quantity 1. NOTE: Number each tappet with the cylinder number position as it is removed. The tappets must be installed in the same position as removed. Remove the camshaft. For C Series diesel engines, refer to Procedure 001-008 in Troubleshooting and Repair Manual, C Series Engines, Bulletin 3666003. For C Series gas engines, refer to Procedure 001-008 in Troubleshooting and Repair Manual, C8.3G (Natural Gas) Engines, Bulletin 3666206. Insert the valve tappet tray.