Cummins — 3666003

Tappet C Series Page 4-6 Section 4 - Cam Followers/Tappets - Group 04 Make sure the valve tappet tray is positioned so it will catch the tappet when the wooden dowels are removed. Only remove one tappet at a time. Remove the rubber band from the two companion tappets, securing the tappet not to be removed with the rubber band. Pull the wooden dowel from the tappet bore, allowing the tappet to fall into the plastic tray. NOTE: The tappet must be in the horizontal position to remove it from the camshaft bore. When the tappet is dropped into the tray, it will fall into the horizontal position. If it does not , gently shake the tray to allow the tappet to fall over.