C Series Tappet Section 4 - Cam Followers/Tappets - Group 04 Page 4-7 Carefully pull the tray and tappet from the cam bore and remove the tappet. Repeat the process until all tappets are removed. Oil Pan Removed To reduce the possibility of personal injury, avoid direct contact of hot oil with your skin. WARNING WARNING Some state and federal agencies have determined that used engine oil can be carcinogenic and cause reproductive toxicity. Avoid inhalation of vapors, ingestion, and prolonged contact with used engine oil. If not reused, dispose of in accordance with local environmental regulations. Remove the oil pan. Refer to Procedure 007-025.
Rotate the crankshaft with engine barring gear, Part Number 3377371, to access the tappets. NOTE: Only four tappets are accessible at one time. The crankshaft must be rotated three times to access all of the tappets. NOTE: Number each tappet with the cylinder number position as it is removed. The tappets must be installed in the same position as removed. Remove the rubber bands from the wooden dowels that are used to hold the tappets up during camshaft removal. NOTE: Only remove the rubber bands from the accessible tappets.