C Series Tappet Section 4 - Cam Followers/Tappets - Group 04 Page 4-9 Pit marks on the tappet face are acceptable. The following criteria define the size of the pits allowed: 1. A single pit can not be greater than 2 mm [0.078 in]. 2. Interconnection of pits is not allowed. 3. Total pits added together must not exceed 6-mm [0.236-in] diameter or a total of 4 percent of the tappet face. 4. No pitting is allowed on the edges of the wear face of the tappet. Inspect the socket, stem, and face for excessive wear, cracks, and other damage. Visual Limits (A) - Normal Contact (exaggerated) (B) and (C) - Irregular Contact: Do not reuse. Measure the valve tappet stem diameter.
Valve Tappet Stem Diameter mm in 15.93 MIN 0.627 15.98 MAX 0.629 Measure the valve tappet height. Valve Tappet Height mm in 60 MAX 2.36 Install Oil Pan Installed Insert the valve tappet tray the full length of the cam bore.