Cummins — 3666003

Tappet C Series Page 4-10 Section 4 - Cam Followers/Tappets - Group 04 Lower the tappet installation tool down the push tube hole, through the tappet bore, and into the tray. Feed the installation tool through the cam bores by carefully pulling the plastic tray/installation tool out the front of the cylinder block. NOTE: If the tappets to be installed have been previously used, each tappet must be installed in the same position as it was removed from the engine. Lubricate the tappets with clean engine oil. NOTE: To aid in removing the installation tool after the tappet is installed, work the tool in and out of the tappet several times before installing the tappets.

Insert the installation tool into the tappet.