C Series Tappet Section 4 - Cam Followers/Tappets - Group 04 Page 4-11 Pull the installation tool and tappet through the cam bore and up into the tappet bore. NOTE: If difficulty is experienced in getting the tappet to make the bend from the tray up to the tappet bore, pull the tray out enough to allow the tappet to drop down and align itself; then pull the tappet up into the bore. After the tappet has been pulled up into position, slide the tray back into the cam bore and rotate it a Ѕ turn. This will position the round side of the tray up and hold the tappet in place. Install a wooden dowel into the top of the tappet. Wrap rubber bands around the wooden dowels to secure the tappets.
Remove the installation tool from the tappet. Repeat this process until all tappets have been installed.