Cummins — 3666003

Fuel Injection Pumps, In-Line C Series Page 5-6 Section 5 - Fuel System - Group 05 Fuel Injection Pumps, In-Line (005-012) Preparatory Steps WARNING Fuel is flammable. Keep all cigarettes, flames, pilot lights, arching equipment, and switches out of the work area and areas sharing ventilation to reduce the possibility of severe personal injury or death when working on the fuel system. WARNING Some state and federal agencies have determined that used engine oil can be carcinogenic and cause reproductive toxicity. Avoid inhalation of vapors, ingestion, and prolonged contact with used engine oil. If not reused, dispose of in accordance with local environmental regulations.

Clean any debris from the fuel injection pump. Remove the fuel supply lines. Refer to Procedure 006-024. Remove the injector supply lines. Refer to Procedure 006-051. Remove the control linkage. Refer to the OEM service manual. Remove the fuel shutoff solenoid. Refer to Procedure 005-043. Remove the air fuel control air line. Remove the governor oil supply line. Time Marine Applications Do not use the timing pin to locate engine top dead center for marine applications. This can result in incorrect timing, poor engine performance, and engine smoke problems. CAUTION To locate actual top dead center, fabricate a timing mark pointer for the front of the engine. NOTE:

This can be done by forming a piece of 16 gauge wire that can be tightened under one of the gear cover capscrews. Sharpen the wire at the vibration damper end so that it comes to a point for better accuracy.