C Series Fuel Injection Pumps, In-Line Section 5 - Fuel System - Group 05 Page 5-7 Locate top dead center for cylinder Number 1 by barring crankshaft slowly while pressing on the engine timing pin. Barring the engine is recommended from the flywheel on the rear of the engine using barring tool, Part Number 3824591. To prevent damage to the engine or timing pin, you must disengage the timing pin after locating top dead center. Rotate the crankshaft 90 degrees in the direction opposite normal rotation ( counterclockwise ). Tighten the adjusting screw for the intake valve on number 1 cylinder three complete turns of the screw. NOTE:
Leave the adjusting screw in this position until top dead center is established.