Fuel Injection Pumps, In-Line C Series Page 5-8 Section 5 - Fuel System - Group 05 Use extreme care that the piston does not push against the valve with so much force that it bends the push rod or valve. CAUTION Rotate the crankshaft slowly in the direction of the engine rotation until the piston touches the intake valve. Place a mark on the vibration damper at the tip of the pointer. CAUTION Make certain that the piston does not push against the valve with so much force that it bends the push rod or valve. Rotate the crankshaft in the opposite direction until the piston touches the intake valve. Place a mark on the vibration damper at the tip of the pointer.
Measure the distance and mark the damper at one-half the distance between the two marks. This mark is the top dead center mark. Failure to loosen the adjusting screw will result in bending the push rod and/or valve stem when the crankshaft is rotated. CAUTION Loosen the intake valve adjusting screw and reset the valve to the proper clearance. Refer to Procedure 003-004.