Fuel Injection Pumps, In-Line C Series Page 5-10 Section 5 - Fuel System - Group 05 Automotive and Industrial Use cylinder number 1 intake valve to make certain that the engine is at top dead center on the compression stroke for cylinder number 1. Refer to Procedure 001-049. Fabricate a timing marker for the front of the engine. NOTE: This can be done by forming a piece of 16 gauge wire that can be tightened under one of the gear cover capscrews. Sharpen the wire at the vibration damper end so that it comes to a point for better accuracy. Attach a degree wheel or degree tape to the front of the vibration damper. Line the top dead center mark up with the pointer.
The degree wheel/tape must measure to an accuracy of at least ±1 degree. Fuel is flammable. Keep all cigarettes, flames, pilot lights, arching equipment, and switches out of the work area and areas sharing ventilation to reduce the possibility of severe personal injury or death when working on the fuel system. WARNING Install the fuel injection pump. See the Install section. If the fuel injection pump is already installed, continued the procedure.