Cummins — 3666003

Fuel Injection Pumps, In-Line C Series Page 5-24 Section 5 - Fuel System - Group 05 Failure to clean and dry the shaft and gear tapers thoroughly can result in timing shift to the retarded side after the engine is started and running under a load. This will result in low power, smoke, rough running, and engine damage. CAUTION Tighten the fuel injection pump drive gear nut. Torque Value: Nippondenso Step 1 123 N•m [ 91 ft-lb ] Torque Value: Bosch® A pump Step 1 85 N•m [ 63 ft-lb ] Torque Value: Bosch® MW pump Step 1 105 N•m [ 77 ft-lb ] Torque Value: Bosch® P3000/P7100 Step 1 195 N•m [ 144 ft-lb ] Install the gear cover access cap hand-tight.

Marine Applications CAUTION Do not use the timing pin to locate engine top dead center for marine applications. This can result in incorrect timing, poor engine performance, and engine smoke problems. Make certain that the cylinder number 1 is at top dead center. See the Time, Marine Application procedure. The fuel injection pump also has a timing pin (1), located in the governor housing, to position the fuel injection pump shaft to correspond with top dead center for cylinder number 1. The timing pin must be reversed and stored in the housing (2) after the fuel injection pump is installed. Remove the fuel injection pump timing pin access plug.