Cummins — 3666003

Fuel Injection Pump, In-Line, Spill Port Timing C Series Page 5-30 Section 5 - Fuel System - Group 05 Remove the No. 1 high-pressure fuel line from the fuel injection pump. NOTE: Lines 2 through 6 must not be removed or loosened. CAUTION When attaching the fabricated tube, do not bend the No. 1 high-pressure fuel line. This can cause the inside of the fuel line to flake and cause injector failure. A short length of high-pressure line that is compatible with the fuel lines used on the engine must be bent in a “U” shape and installed onto the delivery valve holder of the fuel injection pump. NOTE:

The line is used to observe when the fuel is or is not flowing through the delivery valve holder assembly. Place a container under the tube to catch the fuel or drain the fuel back into the spill port pump. Remove the overflow valve from the fuel injection pump. Install a 14-mm threaded plug and sealing washer into the fuel return port of the fuel injection pump. NOTE: The fuel return port is located on the inboard front side of the fuel injection pump for automotive in-line applications and on the outboard front side for most industrial applications. Remove the fuel supply line between the fuel filter head and the fuel injection pump. NOTE:

Attach the high-pressure outlet hose from the spill port to the fuel injection pump supply port.