C Series Fuel Injection Pump, In-Line, Spill Port Timing Section 5 - Fuel System - Group 05 Page 5-29 Fuel Injection Pump, In-Line, Spill Port Timing (005-013) Adjust Use Cylinder No. 1 intake valve to make sure the engine is at top dead center on the compression stroke for Cylinder No. 1. Refer to Procedure 001-049. Fabricate a timing mark pointer for the front of the engine. NOTE: This can be done by forming a piece of wire that can be tightened under one of the gear cover capscrews. Sharpen the wire at the vibration damper end so that it comes to a point for better accuracy. Attach a degree wheel or degree tape to the front of the vibration damper.
Line the top dead center mark up with the pointer. The degree wheel/tape must measure to an accuracy of at least ±1 degree. Install the fuel injection pump; refer to Procedure 005-012. If the fuel injection pump is already installed, continue the procedures.