Fuel Injection Pump, In-Line, Spill Port Timing C Series Page 5-34 Section 5 - Fuel System - Group 05 Slowly rotate the crankshaft counterclockwise about 40 degrees past the desired static timing specification. Slowly rotate the crankshaft clockwise until the timing pointer indicates the desired static timing. Install and tighten the retaining nut and washer. NOTE: To prevent damage to the timing pins, do not exceed the torque value given. This is not the final torque value for the retaining nut. Torque Value: 12 N•m [ 106 in-lb ] Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause bodily injury.
WARNING Tighten the fuel injection pump drive nut. Make sure the static timing has not changed after the fuel injection drive nut is tightened to the required specification. NOTE: Before installing the fuel pump drive gear, clean the injection pump shaft and gear tapers with residue-free cleaner, Part No. 3824510, by spraying into the gap between the shaft and the gear. Dry the surface with compressed air. Failure to clean and dry the shaft and gear tapers thoroughly can result in timing shift to the retarded side after the engine is started and running under a load. This will result in low power, smoke, rough running, and engine damage.
CAUTION Tighten the fuel injection pump drive gear nut. Torque Value: Nippondenso 123 N•m [ 92 ft-lb ] Bosch A pump 85 N•m [ 63 ft-lb ] Bosch MW pump 105 N•m [ 77 ft-lb ] Bosch P3000/ P7100 195 N•m [ 144 ft-lb ]