C Series Fuel Injection Pump, In-Line, Spill Port Timing Section 5 - Fuel System - Group 05 Page 5-33 If the flow does not slow down to a drip: 1. Check the position of the governor levers. 2. Make sure cylinder No. 1 is before top dead center on the compression stroke. 3. Turn off the spill port pump. Check the degree wheel on the vibration damper to see what engine degree the timing pointer is indicating. This is spill port static timing. Compare this number to the timing specification for your particular application.
If the fuel injection pump static timing, as measured by the above method, is not within specification, remove the large nut that fastens the fuel injection pump camshaft to the fuel pump drive gear. If the crankshaft has rotated, turn on the spill port pump and rotate the crankshaft to find port closure. Turn off the spill port pump. Using the fuel pump gear puller, Part No. 3824469, pull the fuel injection pump drive gear from the fuel injection pump camshaft taper.