Fuel Lift Pump C Series Page 5-42 Section 5 - Fuel System - Group 05 Disconnect the fuel shutdown solenoid wire. Measure the engine cranking speed with a handheld tachometer, Part Number 3377462. The minimum cranking speed is 120 rpm. CAUTION Leave the shutdown solenoid disconnected for the following check: Disconnect the output pressure line from the fuel lift pump and run it into a container. Crank the engine for 30 seconds and measure the fuel lift pump flow volume. The minimum flow volume is 150 mL [5 oz]. Install Alternately tighten the mounting capscrews. As the capscrews are tightened, the fuel lift pump plunger is pushed into the pump.
Failure to tighten the capscrews in an even manner can result in the plunger being bent or broken, causing sticking and failure. CAUTION Piston Style Install the pump. Torque Value: 24 N•m [ 18 ft-lb ] The 5-mm [0.20-in] spacer (1), Part Number 3914284, must be installed along with a gasket, Part Number 3931348, on each side of the spacer. NOTE: For some applications, a bracket used for supporting other options will replace the 5-mm spacer.