C Series Fuel Lift Pump Section 5 - Fuel System - Group 05 Page 5-41 Remove Remove the two fuel lift pump mounting capscrews. Remove the fuel lift pump. Test The output of the fuel lift pump can be checked in two ways: Test 1: Measure the output pressure using an in-line pressure gauge installed between the filter head and the fuel injection pump. Test 2: Measure the flow volume. Test 1: Output Pressure Test (Piston Style) Operate the engine and measure the output pressure of the fuel lift pump using an in-line pressure gauge at the inlet to the injection pump. Minimum pressure at high idle is 138 kPa [20 psi]. Test 2:
Flow Volume Test (Piston Style) To prevent the engine from starting, disconnect the fuel shutdown wiring. Residual fuel in the injection pump can cause the engine to start. CAUTION CAUTION Do not crank the starter for more than 30 seconds at a time. Doing so can result in starter damage. Also, high voltage during cranking can damage the shutdown solenoid.