Air in Fuel C Series Page 6-2 Section 6 - Injectors and Fuel Lines - Group 06 Air in Fuel (006-003) General Information Air from uncorrected leaks in the supply circuit will make the engine: 1. Difficult to start 2. Run rough 3. Misfire 4. Produce low power 5. Emit excessive smoke 6. Produce fuel knock. The Nippondenso EP-9 in-line fuel injection pumps will require additional venting prior to initial start-up, pump replacement, or if the engine has been run out of fuel. The MW, A, and P fuel injection pumps equipped with engine-side fuel drain arrangement create a self-bleeding system for air introduced during replacement of the supply-side components. NOTE:
For faster air purge, small amounts of air can be bled from the pump by operating the hand primer on the fuel transfer pump or by cranking the engine. A source often overlooked for air to enter the fuel system is between the inlet of the prefilter and the suction tube in the fuel tank. Fuel tanks that have the outlet fitting at the top will have a suction tube that extends to the bottom of the fuel tank. Cracks or pin holes in the weld that join the suction tube to the fitting can let air enter the fuel system. Check all the fittings from the fuel supply on the fuel tank to the fuel inlet of the fuel transfer pump; make sure they are all tight.
Use a sight glass at the fuel transfer pump inlet to check for air in the supply line.