Injector C Series Page 6-22 Section 6 - Injectors and Fuel Lines - Group 06 Pull the needle valve one-third of the way out of the nozzle body. With the needle valve in the vertical position, the needle valve must slide all the way back into the nozzle body under its own weight. If the nozzle does not pass this test, clean and test it an additional time. Any needle valve and nozzle body assembly that does not pass this test must be replaced. Verify that the injector sealing washer is the correct thickness. The incorrect sealing washer can cause high- pressure fuel leaks, and/or performance problems due to incorrect injector protrusion.
Injector Sealing Washer 1.5 mm [ 0.06 in ] Assemble Make sure all mating surfaces and pressure faces are thoroughly cleaned and lubricated with test oil before assembly. New nozzles must be cleaned and lubricated before assembly. Install the same thickness of shim(s) that were removed in disassembly. Use the pressure spring to make sure the shim(s) are installed flat. Install the shim(s) and pressure spring.