Cummins — 3666003

C Series Injector Section 6 - Injectors and Fuel Lines - Group 06 Page 6-21 Clean the spray holes as shown with the appropriate-size cleaning needle. Remove burned-on combustion deposits on all nozzles with a commercially available cleaner. Rinse all parts in clean test oil. Clean the needle valve tip with a brass brush. Inspect for rough surfaces or erosion. The pressure shoulder will normally have a rough machined appearance. Deteriorated needle valves must be replaced as a matched unit with their compatible nozzle body. Inspect the injector. Inspect the o-ring for damage. Inspect for burrs on the inlet to the injector.

Check the nozzle holes for any signs of damage, such as hole erosion or hole plugging. Also, check the nozzle color for sign of overheating. Overheating will cause the nozzle to turn a dark yellow and tan or blue color, depending on the temperature of the overheat. Inspect for rough surfaces or erosion. The pressure shoulder will normally have a rough machined appearance. Inspect the injector bore for old sealing washers. Dip the needle valve in clean test oil, and insert the needle valve all the way into the nozzle body.