Injector C Series Page 6-24 Section 6 - Injectors and Fuel Lines - Group 06 Install Lubricate the sealing lips of the sleeve with anti-seize lubricant, Part Number 3824879. Assemble the injector, sealing sleeve, a new copper sealing washer, and the hold-down clamp. Use only one washer. Service Tip A light coat of clean engine oil between the washer and injector can help hold the washer in place during installation. Install the injector assembly into the injector bore. The injector drain connection must be toward the valve cover. Install and tighten the hold-down capscrew. Torque Value:
28 N•m [ 21 ft-lb ] Finishing Steps WARNING The pressure of the fuel in the line is sufficient to penetrate the skin and cause serious personal injury. Wear gloves and protective clothing. Install the fuel drain lines. Refer to Procedure 006-021. Install the high pressure fuel lines. Refer to Procedure 006-051.