C Series Lubricating Oil Pan Section 7 - Lubricating Oil System - Group 07 Page 7-13 Clean and Inspect for Reuse When using a steam cleaner, wear safety glasses or a face shield, as well as protective clothing. Hot steam can cause serious personal injury. WARNING WARNING Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury. CAUTION When scraping gasket material from the front gear housing, do not gouge into the surface. Damage to the component can occur. Remove all gasket material from the cylinder block and oil pan surfaces. Steam clean the oil pan. Dry with compressed air.
Inspect the lubricating oil pan, suction tube, and tube braces for other damage. If cracks are found, replace the damaged part. Do not attempt to repair the oil pan by welding. Install the suction tube, if required. Refer to Procedure 007-035 in Section 7. Install NOTE: C and L Series engines use a variety of combinations of gaskets and/or RTV for sealing. When installing the oil pan, use the same combinations of gasket and/or RTV that were on the pan. NOTE: Install three guide pins, Part Number 3164977, to improve alignment of the oil pan sealing components to the cylinder block.
Use RTV sealant, or equivalent, to fill the joints between the lubricating oil pan rail, gear housing, and rear seal housing. Install the suction tube, if removed. Refer to Procedure 007-035 in Section 7.