Cummins — 3666003

Lubricating Oil Pump C Series Page 7-20 Section 7 - Lubricating Oil System - Group 07 Tighten the oil pump mounting capscrews in the sequence shown. Torque Value: 24 N•m [ 18 ft-lb ] NOTE: The back plate on the oil pump seats against the bottom of the bore in the cylinder block. When the lubricating oil pump is correctly installed, the flange on the oil pump will not touch the cylinder block. Measure the oil pump gear backlash. Backlash Limits mm in A 0.076 MIN 0.003 0.330 MAX 0.013 B 0.076 MIN 0.003 0.330 MAX 0.013 NOTE: If the adjoining gear moves when you measure the backlash, the reading will be incorrect. Finishing Steps Install the front gear cover and gasket.

Refer to Procedure 001-031. Install the front cover access cap and seal. Install the crankshaft pulley/vibration damper. Refer to Procedure 001-052. Install the drive belt. Refer to Procedure 008-002. Fill the oil pan. Refer to Procedure 007-037.