C Series Lubricating Oil Thermostat Section 7 - Lubricating Oil System - Group 07 Page 7-25 Fill the engine with clean lubricating oil to the proper level. When filling the oil pan, use the fill tube on the side of the engine rather than on top of the rocker lever cover. Refer to Section V for lubricating oil pan capacities. CAUTION If no oil pressure is noted within 15 seconds after the engine is started, shut down the engine to reduce the possibility of internal damage. Idle the engine and inspect for leaks at the drain plug. Shut off the engine. Wait approximately 10 minutes to let the oil drain from the upper parts of the engine and check the level again.
Add oil as necessary to bring the oil level to the “H” (high) mark on the dipstick. Lubricating Oil Thermostat (007-039) Preparatory Steps Clean debris from oil thermostat.