C Series Coolant Thermostat Section 8 - Cooling System - Group 08 Page 8-9 Install the shutoff valve shaft (3) in the thermostat housing (2). Install the retaining ring capscrew (1) in the thermostat housing. Tighten the retaining ring capscrews. Torque Value: 7 N•m [ 60 in-lb ] Coolant Thermostat (008-013) Initial Check WARNING Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury. WARNING Complete this test with the engine coolant temperature below 49°C [120°F]. Hot steam can cause serious personal injury. Drain 2 liters [2.1 qt] of coolant.
Refer to Procedure 008-018. Remove the cooling system hose from the thermostat housing. Install a thermocouple or temperature gauge, which is known to be accurate, in the ѕ-inch pipe plug located at the front of the cylinder block.